Our planner runs your layout in 3D. Forklifts, robots and people move, the sensors trigger, and the projected lines and signs switch on cue. Open any scene live, then change it to match your building.
The Infinity SafeGuide Fixed Laser Line Projector puts one straight, solid laser line on the floor. It has the same laser output as our SafeGuide Adjustable Laser Line Projector — red 700 mW, green 300 mW or blue 1,600 mW — and runs on the same DC 10–80 V vehicle power, drawing just 2–2.5 W. The one difference is the twist ring: this model does not have one. You mount it, aim it, and the line stays the length it is.
That makes it the budget pick for a fleet. When you already know where every line goes — a lane edge beside each forklift, a stay-back line at each dock door — and nobody will need to resize it later, you can put a SafeGuide on every truck for less.
A laser at the back of a compact aluminum head fans out into a single flat sheet of light. Where it meets the floor, you see a crisp line. Use it to mark a lane edge that travels with a forklift, a keep-out boundary beside a lift, a walkway edge, or a straight backing guide at a dock door.
Pick red, green or blue at checkout. Each unit is one color. Because the line length is fixed, the only way to make the line longer or shorter is to mount the unit higher or lower. Tell us your mounting height and the line length you need, and we will confirm the fit before your order ships.
Mount it on the mast or overhead guard and the lane edge travels with the truck, so people on foot see where it is going.
Heads on the chassis mark the ground below the platform as a keep-out zone while the lift is powered.
A green line down each bay gives drivers a straight backing target and dock staff a clear stay-behind line.
Mounted on a column or ceiling with a DC supply, it marks a walkway edge that never wears off under tire traffic.
IP65 and rated -20°C to 55°C (-4°F to 131°F), so it holds a yard lane through rain and cold.
On a vehicle. It runs on DC power from 10 to 80 V and draws 2–2.5 W, so it wires straight into the battery system of most forklifts, reach trucks, scissor lifts and AGVs. Have your fleet technician wire it through the key switch so the line turns off with the truck. The iron bracket bolts to the mast, guard or chassis, and you angle the head until the line lands where you want it.
On a ceiling, column or wall. This is a DC unit, so a fixed install needs a DC power supply in the 10–80 V range. Ask us and we will spec the right one with your order. Mount it above head height and aim it down at the floor.
Size. The head is 57 mm long, 45 mm wide and 50 mm high (2.2 × 1.8 × 2.0 in), with a bracket 56.9 mm (2.2 in) across, so it fits on tight guards and masts.
Fixed or Adjustable? Both SafeGuides use the same laser output and the same DC 10–80 V power. Choose this Fixed model when the line length is known and will not change. Choose the SafeGuide Adjustable when you want to lengthen or shorten the line after it is mounted, with a twist of the ring and no ladder.
Want a zone that turns red when someone walks up? That is the Forklift Safety Zone System. For one long line from a high ceiling on wall power, our plug-in Laser Safety Line Projector (10–40 W) is the stronger tool.
The line length does not adjust. There is no twist ring. If you are unsure of the length you need, tell us your mounting height first or choose the Adjustable model.
One color per unit. Red, green and blue are chosen at checkout and cannot be swapped later. Red reads as stop or keep out; green reads as a guide line and shows up well on gray concrete; blue stands apart from existing red and green markings.
Eye safety. A laser projector is for floors, not for people. Mount it above head height, aim it down at the floor, and never point it at a person, a driver’s seat, a road or a flight path. Tighten the bracket so a bump from a pallet or a door cannot swing the beam into a new aim, and re-check the aim after any collision or maintenance.
Keeping it sharp. Dust and exhaust film the front lens over time. Wipe it with a dry microfiber cloth; if it needs more, dampen the cloth with water only.
Turnaround. Delivers in 2–3 weeks.
Line length by mounting height, weight and warranty terms are not published for this model — ask us if your install needs them.
Dai una valutazione
La tua recensione
Trascina e rilascia i tuoi file multimediali qui o fai clic per caricarli — up to 5 files, 50MB each
Company Name (optional)
Your Name
Your Email
Not published — we only use it to confirm your order and reply to you.
